Xerox Document WorkCentre 450c User Manual page 203

Setting copy collation before
copying a document
By default, the WorkCentre does not collate multiple
copies. You can change the default setting at the control
panel to have the WorkCentre always collate multiple
copies.
Note The WorkCentre stores the document to
memory before printing the collated copies. If the
WorkCentre's memory runs low, it will not collate the
copies.
1. At the WorkCentre 450c, press MENU.
2. Press 5 [Setup] and ENTER.
3. Press 7 [Control panel] and ENTER.
4. Press 7 [Collate copies] and ENTER.
5. Press RIGHT ARROW to display [yes] and ENTER.
6. Press STOP to exit the menus.
The WorkCentre is set to collate multiple copies of the
same document. To copy a document, see the previous
section, "Copying a document.
203