Assembly - The Handy THSS100 Instruction Manual

100lb (45.5kgs) salt spreader
Table of Contents

Advertisement

ASSEMBLY

STEP 1
Install the impeller (42) onto the gearbox and axle assembly.
Align the impeller with the hole on the axle, located nearest the gearbox.
Insert M4x20 screw (41), through the side of the impeller and the gearbox axle. Tighten until
secure.
STEP 2
Attach the outer wheel tubes (20) to the gear assembly using the M6x40 bolt (54); attach the
two connecting plates A & B (31 & 14) to the frame tube (30) and wheel tubes (20) using an
M6x35 bolt (33) and an M6 lock nut (24). Hand tighten.
Connect the back deflector (58) to the frame tube (30) and the wheel tube (20) using an M6x65
bolt (47) and an M6 lock nut (24). Tighten all hardware in Steps 1 and 2.
NOTE: WE ADVISE YOU DO NOT TIGHTEN THE NUTS & BOLTS COMPLETELY AT THIS POINT.

Advertisement

Table of Contents
loading

This manual is also suitable for:

193878002

Table of Contents