Table of Contents
Advertisement
SPECIFICATION
The manufacturer reserves the right to change the product specification and livery according to
continued product improvements.
Model
Product Number
Weight
Capacity (Weight)
Tyre Rating
Tyre Maximum PSI
IMPORTANT INFORMATION
INTENDED USE
The product is intended for spreading granular material for domestic gardens. This product is not
intended for commercial use. Generally acknowledged accident prevention regulations and enclosed
safety instructions must be observed.
ONLY REFINED ICE MELTING SALT CAN BE USED WITH THIS PRODUCT.
Only perform work described in these instructions for use, any other use is incorrect. The
manufacturer will not assume responsibility for damage resulting from such use.
HELPFUL HINTS
If your spreader does not spread evenly, the impeller must turn clockwise. Reversing the gearbox
will cause the impeller to turn counter clockwise. Clean the impeller plate after each use. material
stuck on the impeller blades will cause uneven spreading.
Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed.
Slower or faster speeds will change the spread patterns. Wet material will also change the spread
pattern and flow rate. Clean your spreader thoroughly after each use. Wash between the shut off
plate and the bottom of the hopper.
Gears are lubricated at the factory.
GENERAL SAFETY INSTRUCTIONS
Read and understand the owner's manual
and labels affixed to the product. Learn its
application and limitations as well as the
specific potential hazards. Retain these
instructions for future reference. The
operator is responsible for following the
warnings & instructions in this manual and
on the product.
STAY ALERT
Do not operate the machine while under the
influence of drugs, alcohol, or any medication
that could affect your ability to use it
properly. Do not use this machine when you
are tired or distracted from the job at hand.
Be aware of what you are doing at all times.
Use common sense.
THSS100
193878002
12.9kg
45.5kg
2 Ply
25psi (Do not exceed)
AVOID DANGEROUS CONDITIONS
Make sure there is adequate surrounding
workspace. Cluttered areas invite injuries.
Keep your work area clean with sufficient
light. Keep the area around the machine clear
of obstructions, grease, oil, rubbish & other
debris which could cause persons to fall onto
moving parts.
INSPECT YOUR MACHINE
Check all bolts, nuts & screws for tightness
before each use, especially those securing
guards & drive mechanisms. Vibration during
use, may cause these to loosen. Replace
damaged, missing or failed parts before using.
Warning labels carry important information.
Replace any missing or damaged warning
Advertisement
Table of Contents
