Assembly Instructions - The Handy THS125 Operator's Manual And Parts List

125lb push spreader

Hide thumbs Also See for THS125:

STEP 1: Installing the Wheels

1. On the left side of the axle install a wheel bushing and wheel spacer onto the axle.

2. Slide a wheel over the axle.

3. Put a Ø16 flat washer over the axle, insert the cotter pin through the hole and secure by bending.

4. On the right side of the axle slide a wheel bushing and the wheel spacer onto the axle.

5. Put a wheel over the axle, line up the holes and insert the drive pin through sleeve and lock.

6. Put a Ø16 flat washer over the axle, insert the cotter pin through the hole and secure by bending.

NOTE: Four additional flat washers are provided for adjusting the gap between the wheels.

Assembly Instructions

- 8 -

Table of Contents