Table of Contents
Advertisement
ADJUSTMENTS
If when you have finished all of the above steps and the holes at the bottom of hopper cannot be
opened and completely closed by using the handle, you will need to follow the instructions below.
1. Loosen the wing nut and move the lever to the lowest position to close the adjustable plates.
2. Move the lever to the highest position to open the adjustable plates.
3. If the adjustable plates are not completely open when the lever is in the highest position, loosen the
bottom nut on the control rod.
4. Match up the holes on the hopper and adjustable plate so they are fully open.
5. Retighten the control rod nut and check to make sure the adjustable plate operates properly when
the lever is moved to the lowest and highest positions.
6. Insert the screen (48) and attach the rain cover (51).
7. Tighten all hardware before operating the spreader.
NOTE: The holes in the bottom of the hopper and the adjustable plate must line up.
Move lever to the
lowest position to close
the adjustable plates.
Move the lever to the
highest position to
open the adjustable
plates.
Loosen the wing nut to
set the flow control
lever to the proper
spreader setting
Loosen the bottom nut on the
control rod to adjust the holes in the
hopper. The holes in the hopper
need to line up with the adjustable
plate. When the lever is moved to
the lowest position the holes should
close. When the lever is moved to
the highest position the holes should
open fully.
.
Advertisement
Table of Contents
