Table of Contents
Advertisement
RATE SETTINGS
Our spreaders are designed to spread dry, powdered or granulated materials thinly and evenly over
reasonably smooth surfaces.
•
Ensure that the material is dry and free-running. If in doubt pass it through a sieve with 3mm
mesh to remove lumps.
•
Set rate-setting dial to No 2.
•
Fill the hopper approximately 3/4 full.
•
Push the spreader forward and pull the control lever back to the Stop bolt. If the spread is
uneven or inadequate, close the feed-gate and reset the dial to a higher number.
Always move off BEFORE opening the feed-gate and close the gate BEFORE stopping.
CAUTION
The rate settings are guidelines only. Even branded materials may vary in grain size, humidity,
density etc. If in any doubt choose a lower setting than that suggested or start at setting no. 2 and
adjust as necessary, until an even spread is achieved.
WARNING
Do not over apply spreading material. Follow the recommended coverage rate for each product.
Over application will lead to damage and contamination. If spreading material accidentally
deposits too heavily, soak the area thoroughly with a garden hose or sprinkler to prevent burning.
ADJUSTING THE FLOW
•
For proper material flow settings refer to the spreading instructions section.
•
Move the bolt on the flow control assembly to the proper setting and tighten.
•
Pushing the spreader forward at brisk walking speed will ensure consistent coverage of material.
•
Before stopping, move the flow control lever to the closed position.
CONSISTENT COVERAGE
To ensure consistent coverage, ensure each broadcast pattern slightly overlaps the previous, as
shown below. N.B. ALWAYS MOVE OFF BEFORE OPENING FEED-GATE.ALWAYS CLOSE FEED-GATE
BEFORE STOPPING
Advertisement
Table of Contents
