Insert Ic Core - Assa Abloy Corbin Russwin CL3100 Series Installation Instructions Manual

Grade 1 Key-In-Lever VR Lever Lock
CL3100 Series
Installation Instructions
13 IC Cylinder and Levers - Installation / Removal (cont.)
d

Insert IC Core

1. Insert 6- or 7-pin tailpiece, with appropriate spacer disk,
into the two (2) holes on the back of the cylinder core.
(See spacer type below).
2. Insert control key and turn counter clockwise.
3. Slide core into lever. If core will not fully insert, the cam may
need adjustment for proper tailpiece - slot alignment.
4. Rotate control key clockwise to lock in lever.
5. Remove control key. Hold cylinder with finger and remove key.
SFIC
6- or 7-pin
Figure 20
Tailpiece Installation
For Installation Assistance contact Corbin Russwin
1-888-607-5703 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2016, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Tailpiece
6-pin SFIC
spacer
7-pin SFIC
spacer
End cap
Schalge tailpiece
Note retaining ring location
Schlage core
1
Figure 19
Core Lever Installation
7-pin LFIC
spacer
Corbin Russwin
LFIC 6- or 7-pin
Spacer Type
Core Type Thickness
6-pin LFIC
0.197
Pyramid
7-pin LFIC 0.055
6-pin SFIC 0.234
Core Type 0.093
11
5
4
3
2
Tailpiece
6-pin LFIC
spacer
Color/Material
Blue/Delrin
Steel-Zinc Plate
Black/Delrin
Black/Delrin
FM345 01/19