Table of Contents
Advertisement
Grade 1 Key-In-Lever VR Lever Lock
CL3100 Series
Installation Instructions
15
Dummy Trim Installation (cont.)
CL3350/70 Half/Full Dummy Trim D Rose
1. Align mounting plate on both sides of the door with the five (5) holes prepared in the door.
Note
The dimple faces the door edge.
2. Install screw from the opposite side of the door.
Note
Mounting plate with clearance hole and threaded hole.
2A. Install washer and screw from the opposite side of the door (half dummy).
3. Install four (4) surface screws (#4 flat head Phillips screws) in the mounting plate.
4. Align and place the rose support plate on both sides of the door.
Note
The flanges are pointing away from the door.
5. Place and tighten rose support plate collar with CL3100 wrench.
6. Install rose.
7. Install lever.
8. Tighten 6 lobe security set screws.
PLEASE REFERENCE
TEMPLATE: T31194
Flange facing
outward
For Installation Assistance contact Corbin Russwin
1-888-607-5703 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2016, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Half
Dummy
Trim
Clearance hole
Threaded hole
reverse of flange
Dimple
Figure 25
Dummy Trim Installation D
Flange facing
outward
Full
Dummy
Dimple
Trim
14
FM345 01/19
Advertisement
Table of Contents
