Lever Installation - Assa Abloy Corbin Russwin CL3100 Series Installation Instructions Manual

Grade 1 Key-In-Lever VR Lever Lock
CL3100 Series
Installation Instructions
Function Specific Directions - Lever Installation
For functions not shown, proceed to step 9, Lever Installation.
Inside Sleeve
Lock lever by button.
Align tailpiece and tailpiece slot in cam.
Rotate key 45° CW until lever catch
button can be depressed. Install lever.
Rotate cam CCW until it stops.
Rotate cam CCW until it stops. Then
rotate back 45° until lever catch button
can be depressed.
Rotate cam CCW until it stops.
9

Lever Installation

1. For conventional cylinder, place cylinder into lever.
Insert key and turn 45° CLOCKWISE to align cylinder
tailpiece with cylinder tailpiece slot in cam
(cam orientation - page 7 step 7).
NOTE
6-pin standard cylinder requires a spacer
for cylinder to seat properly in the lever.
For IC cylinder/lever removal and installation,
see page 10 step 13.
2. Install outside lever. Push on lever until lever engages.
3. Secure with 6 lobe security set screw until tight.
4. Install inside lever.
5. Secure with 6 lobe security set screw until tight.
6. Complete tightening of two (2) latch bolt screws.
7. Check operation of levers and latch bolt
before closing door.
TEST OPERATION:
Rotate levers to see that latchbolt moves
DO NOT FORCE .
freely.
operate properly, remove lockset from door
and check door preparation.
For Installation Assistance contact Corbin Russwin
1-888-607-5703 • techsupport.corbinrusswin@assaabloy.com
Copyright © 2016, 2019, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Function
Number
CL3120
CL3161
CL3151
CL3193
CL3157
CL3132
Exits/Public Toilets/
CL3172
CL3162
CL3152
CL3155
CL3175 Corridor/Dormitory Lock
If lockset does not
Function
Description
Privacy/Bedroom/ Rotate cam with emergency key until lever
Bathroom
Entry/Office
Entrance/Office
Service Station
Storeroom/Closet
Align tailpiece and tailpiece slot in cam. Rotate
Utility/Institutional key 45° CW until lever catch button can be
Apartment
Communicating
Rotate cam CCW until it stops. Then rotate
back 45° until lever catch button can be
Classroom Intruder
Classroom
4
Inside
Inside
5
6
Figure 12 Lever Installation
7/16 7/16"
7-pin
7 PIN
standard tail
STD TAIL
Outside Sleeve
catch button can be depressed.
Rotate cam until lever catch button
can be depressed.
depressed. Install lever.
Rotate cam until lever catch button
can be depressed.
depressed.
Installation
Lever catch
Lever catch
Tailpiece
Tailpiece
Shown with Shown with
1
6-pin spacer 6-pin spacer
Cam
Cam
(inside sleeve)
(inside sleeve)
3
Outside
Outside
5/8
5/8"
6-pin standard tail
6 PIN STD TAIL
and spacer
AND SPACER
Figure 13
Lever Tails
8
Sleeve
2
1
45°
45°
FM345 01/19