Table of Contents
Advertisement
Network Deployment Options
Before getting started it is important to determine how the E1000 will be deployed. When considering deployment options for the
E1000, please note that all bypass pairs will default to Fail-To-Block until configured otherwise.
Example instructions for some of the most common deployment scenarios are provided below:
E1000 as a Router (Gateway, Fail to Block)
Description: The E1000 is deployed as the WAN gateway for the site, and bypass pairs are configured as Fail-To-Block. Use this
design if you plan to use the Talari Appliance as the edge device for the site. Proceed to the pages below based on your installation
method:
st
Easy 1
Install:
Manual Install:
E1000 as Layer 2 Fail-To-Wire (Overlay)
Description: The E1000 is deployed on the LAN side of the gateway, and bypass pairs are configured as Fail-To-Wire. Use this
design if you prefer to retain existing edge devices or plan to install an alternative edge device on the WAN side of the Talari
Appliance. Proceed to the pages below based on your installation method:
st
Easy 1
Install:
Manual Install:
E1000 with MPLS & Internet Hybrid
Description: The E1000 is deployed as an overlay for MPLS while performing routing/firewall capabilities for internet links. Use this
design if recommended by your SA, or if you have an MPLS/Internet hybrid network and will not be using the CE Router Replacement
functionality of the Talari APN. Proceed to the pages below based on your installation method:
st
Easy 1
Install:
Manual Install:
Other Options
There are other deployment options, and our Talari Implementation team members will assist you with planning and deploying your new
appliance.
Version 1.1
Page 14
Page 18
Page 14
Page 18
Page 14
Page 18
1 4
Advertisement
Table of Contents
