Power Jumper Contacts/Field Supply; Cage Clamp; Figure 3: Cage Clamp ® Connectors; Table 5: Legend For Figure „Cage Clamp ® Connectors - WAGO 750-461 Series Manual

18 Device Description
Pos: 21.11 /Serie 750 (WAGO-I/O-SYSTEM)/Gerätebeschreibung (alte Struktur)/Anschlüsse/Leistungskontakte/Feldversorgung - Überschrift 3 @ 6\mod_1256294692864_21.docx @ 43664 @ 3 @ 1
3.2.2

Power Jumper Contacts/Field Supply

Pos: 21.12 /Serie 750 (WAGO-I/O-SYSTEM)/Gerätebeschreibung (alte Struktur)/Anschlüsse/Leistungskontakte nicht vorhanden @ 8\mod_1281073936319_21.docx @ 62530 @ @ 1
The I/O module 750-461 has no power jumper contacts.
Pos: 21.13 /Serie 750 (WAGO-I/O-SYSTEM)/Gerätebeschreibung (alte Struktur)/Anschlüsse/CAGE CLAMP-Anschlüsse - Überschrift 3 @ 6\mod_1256296337770_21.docx @ 43674 @ 3 @ 1
3.2.3

CAGE CLAMP

Pos: 21.14 /Serie 750 (WAGO-I/O-SYSTEM)/Gerätebeschreibung (alte Struktur)/Anschlüsse/AI/Anschlüsse 750-0461 @ 10\mod_1298879931582_21.docx @ 70289 @ @ 1
Figure 3: CAGE CLAMP
Table 5: Legend for Figure „CAGE CLAMP
Channel
1
2
Pos: 21.15 /Serie 750 (WAGO-I/O-SYSTEM)/Wichtige Erläuterungen (alte Struktur)/Sicherheits- und sonstige Hinweise/Hinweis/Hinweis: Geschirmte Signalleitungen verwenden! @ 7\mod_1265723251019_21.docx @ 50140 @ @ 1
Use shielded signal lines!
Only use shielded signal lines for analog signals and I/O modules which are
equipped with shield clamps. Only then can you ensure that the accuracy and
interference immunity specified for the respective I/O module can be achieved
even in the presence of interference acting on the signal cable.
Pos: 21.16 /Dokumentation allgemein/Gliederungselemente/---Seitenwechsel--- @ 3\mod_1221108045078_0.docx @ 21810 @ @ 1
Manual
Version 1.4.1
®
Connectors
®
Connectors
®
Connectors"
Designation Connector
+R1
RL1
−R1
Shield
+R2
RL2
−R2
Shield
WAGO-I/O-SYSTEM 750
750-461 2AI Pt100/RTD
Function
1 Sensor 1: +R
2 Sensor 1: RL
3 Sensor 1: −R
4 Shield (screen)
5 Sensor 2: +R
6 Sensor 2: RL
7 Sensor 2: −R
8 Shield (screen)