Champion DH6000T-VHR Installation Manual page 29

PW = 7777
DE T ER GENT
CYCLE TIMES
CONCENTRATION
RINSE AID
NOTE: Press the button, enter "7777" and Enter on the keypad to access
cycle times, concentration, and rinse-aid. Prime buttons are not password
protected.
Cycle Times -
Initial Fill: Sets time detergent pump
runs during machine fill.
Factory Default Initial Fill Setting:
Enter 4 for Sodium Hydroxide based detergent
Enter 30 for Potassium Carbonate based detergent
Prime: Sets the time detergent pump runs to prime detergent line when:
• machine is turned on for first time and line is initially charged or reset button is
pressed to clear an alarm.
• Factory Default Prime Setting: 30 sec.
Detergent Concentration -
• Set Point and Concentration are relative values and not indicative of actual PPM or concen-
tration.
• For best results: Consult the chemical manufacturer's recommendation for concentration
and PPM.
• Perform a titration test to determine the proper concentration has been achieved.
Set Point: Sets required detergent concen-
tration in wash tank measured in millivolts.
Concentration: Actual value being measured
in the tank measured in millivolts.
Tank Temp: The detergent sensor will not add
detergent unless the tank temperature is greater
than 150°F and one complete wash cycle has run.
Factory Default Set Points:
Enter 300 for Sodium Hydroxide based detergent.
Enter 500 for Potassium Carbonate based detergent.
Cycle Times, Concentration, and Rinse Aid
LEGEND - Detergent/Rinse-aid Settings
DET PRIME
RA PRIME
BACK
CYCLE TIMES Sets the run times for the detergent pump
CONCENTRATION Sets detergent concentration in wash tank
RINSE AID Sets the rinse-aid pump run time
DET PRIME Press to prime Detergent pump
RA PRIME Press button to prime rinse-aid pump
BACK Returns to main settings screen above
Installation
4
30
The tank detergent sensor must
remain clean to ensure accurate
readings. Clean sensor with a
soft cloth each day.
13