Graco XM PFP Setup & Operation page 18

Setup
Connect Modules
Regardless of the chosen module configuration, the A
feed module must be on the left and the B feed module
must be on the right when looking at the front of the
system module. The A module has a blue A sticker on
the air control panel and a 1/2 in. return fitting into the
tanks. The B module has a green B sticker on the air
control panel and a 3/8 in. return fitting into the tanks.
Frame Connection Parts
Part Description
115211 SCREW, cap, hex head; 5.5 in
16J674 SCREW, cap, flange hd; 1.5 in
124869 SCREW, cap, hex head; 3.5 in
109570 WASHER
112731 NUT
Choose one of the configurations shown in F
bolt together the three modules on a flat surface. See
F . 10 or F . 11 for bolt locations. The frame bolts are
IG IG
included in a bag. Once connected, the assembly can
be moved as one piece with a fork-truck.
NOTICE
Do not use motor lift rings to lift the entire assembly.
This will damage the system. The system must be
lifted from the bottom.
If the modules will not be connected, they must be within
12 in. of each other and in one of the two configurations
in F . 9 to ensure hoses and cables can reach their
IG
connections.
If the front-to-back module configuration is used, install
the two supplied straight steel horizontal braces
between each feed module and the sprayer module, see
18
F . 11. These are not used in the side-by-side module
IG
configuration.
2 X 115211
Qty
2 X 109570
2
2 X 112731
8
8
20
10
8 X 16J674
. 9 then
IG
F . 10: Bolt Locations (Side by Side)
IG
4 X 100679
4 X 109570
4 X 112731
10 X 16J674
F . 11: Bolt Locations (Front to Back)
IG
Horizontal Braces
1 X 109570
5.5 in. long
1 X 115211
1 X 112731
3A2776K