Before removing the NFC module cable, follow these steps:
1.
Prepare the computer for disassembly
2.
Remove the service cover
1.
Battery (see
2.
Solid-state drives 3 and 4 (see
3.
Solid-state drive carrier (see
4.
Hard drive (see
5.
Keyboard (see
6.
Bottom case (see
Remove the NFC module cable:
1.
Release the ZIF connector (1) to which the NFC module cable is connected, and then disconnect the NFC
module cable from the system board.
2.
Release the ZIF connector (2) to which the NFC module cable is connected, and then disconnect the NFC
module cable from the SD card board.
3.
Detach the NFC module cable (3) from the top cover. (The NFC module cable is attached to the top cover
with double-sided adhesive.)
4.
Remove the NFC module cable (4).
Reverse this procedure to install the NFC module cable.
NFC module
To remove the NFC module, use this procedure and illustration.
76
Chapter 6 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Service cover on page
Battery on page
41)
Solid-state drives 3 and 4 on page
Solid-state drives 3 and 4 on page
Hard drive on page
44)
Keyboard on page
54)
Bottom case on page
40), and then remove the following components:
42)
66)
66).
42)
ENWW