Solid-State Drive 2 - HP ZBook Fury 17 G7 Maintenance And Service Manual

4. If the WWAN antenna is not connected to the terminal on the WWAN module, a protective sleeve must be
installed on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WWAN module.

Solid-state drive 2

To remove solid-state drive 2, use this procedure and illustration.
Table 5-7 Solid-state drive description and part number
Description
Only NVMe solid-state drives can be used in solid-state drive compartment 2.
1 TB, M.2 2280, PCIe, NVMe-3×4, SS with TLC
512 GB, M.2 2280, PCIe, NVMe, SED with TLC
256 GB, M.2 2280, PCIe, NVMe, SED with TLC
Before removing solid-state drive 2, follow these steps:
1. Prepare the computer for disassembly
2. Remove the service cover
3. Remove the battery (see
Remove solid-state drive 2:
1. Remove the Phillips M2.0 × 2.9 screw (1) that secures the solid-state drive cover to the computer.
2. Lift the right side of the cover (2) until it rests at an angle.
ENWW
(Preparation for disassembly on page
(Service cover on page 40).
Battery on page 41).
Spare part number
L85348-001
L85368-002
M07245-001
66).
Component replacement procedures 49