HP ZBook Fury 17 G7 Maintenance And Service Manual page 100

Table 6-9 Beam connector description and part number
Description
Beam connector (includes plastic installation tool and replacement thermal material)
The beam connector ships attached to a plastic installation tool which is packaged inside a sealed plastic container. Extra precautions have
been taken to prevent any unnecessary contact with the pins on the beam connector, which are delicate. Take every precaution not to
directly touch the beam connector when installing the beam connector.
Before removing the beam connector, follow these steps:
1. Prepare the computer for disassembly
2. Remove the service cover
1. Battery (see
2. Solid-state drives 3 and 4 (see
3. Solid-state drive carrier (see
4. Hard drive (see
5. Keyboard (see
6. Bottom case (see
7. Fan/heat sink assembly (see
Remove the beam connector assembly:
1. Remove the three Phillips M2.0 × 2.9 broad head screws (1) that secure the beam connector and bracket to
the computer.
2. Remove the beam connector bracket (2).
The beam connector bracket will be reused when installing the new beam connector.
3. Remove the beam connector (3).
86 Chapter 6 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Service cover on page
Battery on page 41)
Solid-state drives 3 and 4 on page
Solid-state drives 3 and 4 on page
Hard drive on page 44)
Keyboard on page 54)
Bottom case on page
Fan/heat sink assembly on page
40), and then remove the following components:
42)
66)
79)
Spare part number
M25737-001
66).
42)
ENWW