2.
Detach the RTC battery (2) from the top cover/keyboard. (The RTC battery is attached to the top cover/
keyboard with double-sided adhesive.)
3.
Remove the RTC battery.
Reverse this procedure to install the RTC battery.
NFC module cable
To remove the NFC module cable, use this procedure and illustration.
NOTE:
The NFC module cable is included in the Cable Kit, spare part number N09289-001.
Before removing the NFC module cable, follow these steps:
1.
Prepare the computer for disassembly (see
2.
Remove the bottom cover (see
3.
Remove the battery (see
Remove the NFC module cable:
1.
Release the ZIF connector (1) to which the NFC module cable is connected, and then disconnect the NFC
module cable from the system board.
2.
Release the ZIF connector (2) to which the NFC module cable is connected, and then disconnect the NFC
module cable from the NFC module.
Preparation for disassembly on page
Bottom cover on page
Battery on page
43).
41).
41).
NFC module cable
65