Touchpad - HP ZBook Fury 17 G7 Maintenance And Service Manual

5. Keyboard (see
6. Bottom case (see
Remove the touchpad cable:
1. Detach the touchpad cable (1) from the top cover. (The touchpad cable is attached to the top cover with
double-sided adhesive.)
2. Release the ZIF connector (2) to which the touchpad cable is connected, and then disconnect the touchpad
cable from the system board.
3. Release the ZIF connector (3) to which the touchpad cable is connected, and then disconnect the touchpad
cable from the touchpad.
4. Remove the touchpad cable (4).
Reverse this procedure to install the touchpad cable.

Touchpad

To remove the touchpad, use this procedure and illustration.
Table 6-4 Touchpad description and part number
Description
NOTE: The touchpad spare part kit does not include the touchpad bracket or touchpad cable. The touchpad bracket is not available as a
spare part. The touchpad cable is available in the Cable Kit, spare part number M20105-001.
For use only on computer models equipped with NFC capability (includes NFC antenna)
For use only on computer models not equipped with NFC capability
Before removing the touchpad, follow these steps:
74 Chapter 6 Removal and replacement procedures for authorized service provider parts
Keyboard on page 54)
Bottom case on page 66)
Spare part number
M38137-001
M36390-001
ENWW