Blinking Lights And Boot Error Codes; Processor Not Executing Code; Bios Recovery Code Unable To Find Valid Bios Recovery Image; Memory Module Error - HP ZBook Fury 17 G7 Maintenance And Service Manual

Blinking lights and boot error codes

In some cases, when the host processor is not executing code or does not have the necessary code to drive the
display, light blink codes inform you of a problem.
The following information is from the white paper http://h10032.www1.hp.com/ctg/Manual/c04685655.
Table 7-53 Blinking lights and boot error codes
Blink codes
Amber battery light: blinks 1 Hz continuously
Caps and num lk lights = 1 blink
Caps and num lk lights = 2 blinks
Caps and num lk lights = 3 blinks
Caps and num lk lights = 4 blinks
Caps and num lk lights = 5 blinks
Caps and num lk lights = 6 blinks
Caps and num lk lights = 7 blinks
Caps and num lk lights = 8 blinks

Processor not executing code

This computer experienced a problem due to the failure of certain code to execute, resulting in a failed startup of
the processor.
The issue could be related to the processor or the system board in the computer. If the processor is socketed, be
sure that the processor is seated correctly in the socket. If this error reoccurs, see
on page 101.
NOTE: The computer attempts to notify you of this problem through a series of blinking lights. When you
attempt to turn on the computer from an Off or Hibernated state, lights associated with the
keys both blink once, followed by a pause, and then continue in a repeating pattern.

BIOS recovery code unable to find valid BIOS recovery image

This computer has experienced a problem in locating a valid BIOS image, resulting in a failed startup.
You can resolve this problem by placing a clean copy of the system BIOS on a USB key or in the appropriate hard
drive directory and performing a reboot. If this error reoccurs, see
NOTE: The computer attempts to notify you of this problem through a series of blinking lights. When you
attempt to turn on the computer from an Off or Hibernated state, lights associated with the
lock keys both blink twice, followed by a pause, and then continue in a repeating pattern.

Memory module error

This computer has experienced a memory initialization problem resulting in a failed startup. This issue might be
related to the memory modules in the computer. You can resolve this problem by ensuring that memory
modules are correctly inserted and seated.
ENWW
Error
Embedded Controller unable to load firmware
Processor not executing code
BIOS recovery code unable to find valid BIOS recovery image
Memory module error
Graphics controller error
System board error
Intel Trusted Execution Technology (TXT) Error
Sure Start unable to find valid BIOS Boot Block image
Sure Start has identified a problem (Manual Recovery Policy Set)
General troubleshooting steps on page
General troubleshooting steps
caps lock and num lk
101.
caps lock and num
Additional information 169