Component Replacement Procedures; Preparation For Disassembly; Bottom Case - HP ZBook Fury 17 G7 Maintenance And Service Manual

Component replacement procedures

To remove and replace computer components, use these procedures.
NOTE: HP continually improves and changes product parts. For complete and current information about
supported parts for your computer, go to http://partsurfer.hp.com, select your country or region, and then follow
the on-screen instructions.
You must remove, replace, or loosen as many as 84 screws when you service the parts described in this chapter.
Make special note of each screw size and location during removal and replacement.

Preparation for disassembly

To remove and replace computer components, use these procedures.
See Preparation for disassembly on page 40
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the computer
on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.

Bottom case

To remove the bottom case, use this procedure and illustration.
Table 6-1 Bottom case description and part number
Description
Bottom case
Before removing the bottom case, follow these steps:
1. Prepare the computer for disassembly
2. Remove the service cover
1. Battery (see
2. Solid-state drives 3 and 4 (see
3. Solid-state drive carrier (see
4. Hard drive (see
5. Keyboard (see
Remove the bottom case:
1. Close the computer.
2. Turn the computer upside down with the front toward you.
3. Remove the four Phillips M2.5 × 3.1 (1) screws that secure the bottom case to the computer.
66 Chapter 6 Removal and replacement procedures for authorized service provider parts
for initial safety procedures.
(Preparation for disassembly on page
(Service cover on page
Battery on page 41)
Solid-state drives 3 and 4 on page
Solid-state drives 3 and 4 on page
Hard drive on page 44)
Keyboard on page 54)
40), and then remove the following components:
42)
42)
Spare part number
M20092-001
66).
ENWW