Sd Card Board Cable - HP ZBook Fury 17 G7 Maintenance And Service Manual

SD card board cable

To remove the SD card board cable, use this procedure and illustration.
The SD card board cable is available in the Cable Kit, spare part number M20105-001.
Before removing the SD card board cable, follow these steps:
1. Prepare the computer for disassembly
2. Remove the service cover
1. Battery (see
2. Solid-state drives 3 and 4 (see
3. Solid-state drive carrier (see
4. Hard drive (see
5. Keyboard (see
6. Bottom case (see
Remove the SD card board cable:
1. Detach the SD card board cable (1) from the top cover. (The SD card board cable is attached to the top
cover with double-sided adhesive.)
2. Release the ZIF connector (2) to which the SD card board cable is connected, and then disconnect the SD
card board cable from the system board.
3. Release the ZIF connector (3) to which the SD card board cable is connected, and then disconnect the SD
card board cable from the SD card board.
4. Remove the SD card board cable (4).
68 Chapter 6 Removal and replacement procedures for authorized service provider parts
(Preparation for disassembly on page
(Service cover on page
Battery on page 41)
Solid-state drives 3 and 4 on page
Solid-state drives 3 and 4 on page
Hard drive on page 44)
Keyboard on page 54)
Bottom case on page
40), and then remove the following components:
42)
66)
66).
42)
ENWW