Sd Card Board - HP ZBook Fury 17 G7 Maintenance And Service Manual

Reverse this procedure to install the SD card board cable.

SD card board

To remove the SD card board, use this procedure and illustration.
NOTE: The SD card board spare part kit includes SD card board.
Table 6-2 SD card board description and part number
Description
SD card board
NOTE: The SD card board spare part kit does not include the SD card board cable. The SD card board cable is
available in the Cable Kit, spare part number M20105-001.
Before removing the SD card board, follow these steps:
1. Prepare the computer for disassembly
2. Remove the service cover
1. Battery (see
2. Solid-state drives 3 and 4 (see
3. Solid-state drive carrier (see
4. Hard drive (see
5. Keyboard (see
6. Bottom case (see
Remove the SD card board:
1. Remove the SD card slot bezel (1).
The SD card slot bezel is included in the Plastics Kit, spare part number M20093-001.
2. Detach the SD card board cable (2) from the top cover. (The SD card board cable is attached to the top
cover with double-sided adhesive.)
3. Release the ZIF connector (3) to which the SD card board cable is connected, and then disconnect the SD
card board cable from the system board.
4. Remove the two Philllips M2.0 × 2.9 broad head screws (4) that secure the SD card board to the top cover.
ENWW
(Preparation for disassembly on page
(Service cover on page
Battery on page 41)
Solid-state drives 3 and 4 on page
Solid-state drives 3 and 4 on page
Hard drive on page 44)
Keyboard on page 54)
Bottom case on page
40), and then remove the following components:
42)
66)
Component replacement procedures
Spare part number
M17093-001
66).
42)
69