Touchpad Cable - HP ZBook Fury 17 G7 Maintenance And Service Manual

5. Keyboard (see
6. Bottom case (see
Remove the hard drive cable:
1. Disconnect the hard drive cable (1) from the system board.
2. Release the hard drive cable from the retention clips (2) built into the top cover.
3. Remove the two Phillips M2.5 × 6.0 screws (3) that secure the hard drive cable to the top cover.
4. Remove the hard drive cable (4).
Reverse this procedure to install the hard drive cable.

Touchpad cable

To remove the touchpad cable, use this procedure and illustration.
The touchpad cable is available in the Cable Kit, spare part number M20105-001.
Before removing the touchpad cable, follow these steps:
1. Prepare the computer for disassembly
2. Remove the service cover
1. Battery (see
2. Solid-state drives 3 and 4 (see
3. Solid-state drive carrier (see
4. Hard drive (see
ENWW
Keyboard on page 54)
Bottom case on page
(Preparation for disassembly on page
(Service cover on page
Battery on page 41)
Solid-state drives 3 and 4 on page
Solid-state drives 3 and 4 on page
Hard drive on page 44)
66)
40), and then remove the following components:
42)
Component replacement procedures
66).
42)
73