Honeywell HON R100NG Series User And Maintenance Manual page 66

Cleaning
Tightening torques
Maintaining the
HON P095NG‐MP pilot
User manual for HON R100 gas pressure regulator with HON P095NG pilot
Observe the following cleaning instructions:
 Before assembly, all parts must be cleaned in order to remove any foreign particles
(swarf) and soiling.
 If screws, bolts, or washers are replaced with identical new parts, any oil on these new
parts must first be removed.
Observe the tightening torques below when following the instructions in this section:
Part
Screws
Screws
Proceed as follows:
Figure
Tightening torque
24 Nm
47 Nm
Step Description
1 Unscrew the cap (1).
2 Unscrew the set screw, including the hex
nut.
3 Unscrew the lock nut (1). Remove the lock
nut.
4 Remove the spring plate (1) and the
compression spring (2).
Maintenance
Step
26
40
66