Maintaining The Hon P095Ng-Mp Pilot - Honeywell HON R100NG Series User And Maintenance Manual

Next task
8.5.2 Maintaining the HON P095NG‐MP pilot
Falling components
User manual for HON R100 gas pressure regulator with HON P095NG pilot
Figure
Proceed as follows:
 Maintaining the adjustable restrictor (see page 75)
 Completing the maintenance (see page 76)
 Maintaining the actuator assembly (see page 50)
 Storing the device (see page 78)
Crush and impact hazard posed by components falling or toppling over accidentally.
When working with heavy components that have been removed or are yet to be installed,
injury may result if the components start moving in an uncontrolled manner, e.g., fall down
from the working surface or topple over.
 Place removed components exclusively on level, horizontal working surfaces with enough
load‐bearing capacity.
 If necessary, secure removed components so that they will not fall or topple over.
 Wear the required personal protective equipment.
 Exercise caution when performing the relevant tasks.
Step Description
45 Screw the locknut (1) back in place all the
way.
46 Screw the set screw (1), including the hex
nut, back in.
47 Screw the cap (1) back on.
Maintenance
65