Honeywell HON R100NG Series User And Maintenance Manual page 74

User manual for HON R100 gas pressure regulator with HON P095NG pilot
Figure Step Description
40 Put the spring housing back in place,
Tighten the screws (1), including the
washers, in a criss‐cross sequence. Ob‐
serve the tightening torque information
provided in the table before this section.
41 Insert the compression spring (2) and the
spring plate (1) back in.
42 Take the lock nut. Replace the O‐rings (1, 2)
with new, lubricated O‐rings.
43 Screw the locknut (1) back in place all the
way.
44 Screw the set screw (1), including the hex
nut, back in.
Maintenance
74