Sanyo MCO-18AC UV Instruction Manual page 30

6. Pull out the humidifying pan. (See Fig. 4.)
7. Loosen the two screws securing the fan cover and take off the fan cover. (See Fig. 5.)
8. Lift the duct and remove it from the pins on the rear side. (See Fig. 6.)
Humidifying pan
Fig.4
9. Remove the fan by pulling out the central spring and then by pulling out the fan. (See Fig. 7.)
10. Remove the screw securing the clamp for the side support and remove the clamp. (See Fig. 8.)
11. Lift the side support off of the pins. (See Fig. 9.)
Fan
Fig.7
12. Clean all the attachments with a diluted neutral detergent, and then rinse them thoroughly with
distilled water.
13. Wipe the trays, the inner attachments such as the fan, and the chamber sides with sterilizing alcohol.
Be careful not to leave any residual alcohol.
14. Wipe the inside wall of the chamber with a gauze containing alcohol for sterilization and then wipe off
with a dry gauze.
Fan cover
Fig.5
Clamp
Fig.8
28
Side
support
Fig.9
Duct
Fig.6