Config; General; Host Connection - BT NetAgent Series User Manual

7.2.1
When the ClientMate gets the signal from the NetAgent about the AC power failure or
battery low signals, the ClientMate will based on the configuration below to initiate the
shutdown process. The details of the configuration are here below
Fig.63 ClientMate: Configuration
7.2.1.1

Host Connection

This is to configure how ClientMate connects with NetAgent; NetAgent 9 or UPSilon / RUPS
2000.
SNMP V1 /V2：This is default to connect with NetAgent or NetAgent 9
SNMP V3 ：This only use on NetAgent 9. NetAgent 9 uses
SNMP V3 protocol to connect with ClientMate. When select such communication, it
requires to enter username/ password and appropriate authentication and privacy. ( SNMP
V3 configuration may refer to SNMP of the NetAgent )
UPSilon / RUPS： To connect with UPSilon or RUPS server by entering the IP address of the
PC
Host
Press the "Query" to search the host on the network automatically. If a host located on
different network segment. Please input the IP in the HOST edit box. The IP searched on the
Connect Query:
(N): The NetAgent Host
Issued by: BT
Version no: 6.1
Date: March 2019

Config

General

BT UPS Enterprise SNMP Agent
Page 70 of 103