Ups Properties; Ups Recorded; Test Ups; Warning Threshold Value - BT NetAgent Series User Manual

5.2.3
This page is to set the UPS configuration. Any wrong settings will cause incorrect display
values or disconnection between the UPS and NetAgent.
5.2.3.1
UPS Communication Type
This section is to set up the communication interface of the UPS. (eg. Contact
Closure/Megatec/Phoenixtec/ Megatec 3 phase etc.) Please refer to the UPS manual to set
the correct communication type. Any wrong settings will cause disconnection between the
UPS and NetAgent.
Number of Batteries, Battery Full Charge Voltage (V), Battery Exhausted Charge Voltage (V)
Please refer to the UPS manual to set the value.
Date of last battery replacement (yyyy/mm/dd)
This section is to record the date when the UPS battery was last replaced
5.2.3.2
UPS Data Log
This section is to set how often the UPS data should be logged.
5.2.3.3
Test UPS for every
This section is to schedule the UPS to test once a week or once every two weeks or not to
test
Test UPS on Weekday
This section is to set the UPS to test on a particular day of a week.
Start Time of UPS Test (hh:mm)
This section is to set the UPS to test at a specific time on the test day.
UPS Test Type
This is to select which test to perform.
5.2.3.4
Time out of after lost of connection
This section is to set a period of time after which NetAgent will send a disconnection
warning message. This warning message will be sent after NetAgent has lost contact with
the UPS for the time specified.
Critical Loading (%)
Issued by: BT
Version no: 6.1
Date: March 2019
UPS Configuration

UPS Properties

UPS Recorded

Test UPS

Warning Threshold Value

BT UPS Enterprise SNMP Agent
Page 36 of 103