Remote Control; 10 Second Test; Deep Battery Test; Test Until Battery Low - BT NetAgent Series User Manual

Fig.20 Current Status
5.2.1.4
This page is to provide remote UPS test functions. Choose the test item, then click on
'Apply' to execute it. (Please refer to the UPS manual for individual UPS Test functions.)
If you are using a Contact Closure UPS, you will only be able to use the function ' Turn off
UPS when AC Failed'

10 Second Test

This to perform 10 seconds UPS self test

Deep Battery Test

This function is to execute XX minute deep battery test

Test Until Battery Low

When execute, UPS will test Battery until battery low
Cancel Test
This function is to abort a test when it is executing.
Turn off UPS when AC failed/Reboot UPS
Selecting ' Turn off UPS when AC failed' will turn off the UPS. You can reboot the UPS by
selecting ' Reboot UPS'
Put UPS in Sleep mode for minutes/Wake up UPS
When the UPS is put into Sleep mode, it will not provide power. The UPS will provide power
again after Sleep mode time is complete.
Wake up UPS
When execute such command, UPS will be awake from sleep
Reboot UPS
When execute such command, UPS load would start over.
Issued by: BT
Version no: 6.1
Date: March 2019

Remote Control

BT UPS Enterprise SNMP Agent
Page 31 of 103