Motorola MTR2000 T5544 Instruction / Field Service Manual page 77

On a bench-top, working on
one side of the slide rail as-
sembly at a time...
Note
Working in the cabinet...
68P81096E37-N
06/28/05
Installing Slide Rail Assembly in a Non-Motorola Cabinet
Referring to Figure 5, perform the following procedure to install slide rail option
X346AB.
1. Remove the Inner-Slide Rail from the slide assembly (left and right) by de-
pressing the Slide Locking Latch and sliding the Inner-Slide Rail out from
the slide assembly.
2. Install the Inner-Slide Rail (left) on the Power Supply side by:
- removing the 2 bottom screws from the station power supply EMI cover,
and
- installing the Inner-Slide Rail (left) with the supplied screws.
3. Install the Inner-Slide Rail (right) on the PA side using the holes in the PA
casing.
4. Attach each Outer-Slide Rail to the cabinet Brackets with supplied screws.
Only use the lower slot of each bracket. Leave the screws loose; they will
tightened when the brackets are mounted in the cabinet (step 7).
The left and right Cabinet Bracket sets are identical.
The Locking Tab of each Outer-Slide Rail must face towards the rear of the
cabinet.
5. Install a cage nut in line with clearance hole in Threaded Strip prior to fitting
the Front Bracket to the front cabinet rail.
This nut is required for mounting the station (in step 9).
The cage nuts are provided with the cabinet.
6. Fit the Short Bracket and Long Bracket (with attached Outer-Slide Rail) to
the Front and Rear Cabinet Rails using the Bracket Mounting Screws and
Threaded Strips.
7. Tighten the Outer-Slide Rail hardware after positioning the Outer-Slide Rail
front side in line with the inner surface of the Front Cabinet Rails.
8. Slide the station (with an Inner-Slide Rails mounted on each side) into the
Outer-Slide Rails in the cabinet; an audible snap is heard. Continue sliding
the station in until the station is fully seated.
9. Secure the station to the Front Cabinet Rails with the supplied Station
Mounting Screws.
Installation
19