Motorola MTR2000 T5544 Instruction / Field Service Manual page 75

On a bench-top, working on
one side of the slide rail as-
sembly at a time...
Note
Working in the cabinet...
Note
68P81096E37-N
06/28/05
Installing Slide Rail Assembly in a Motorola Cabinet
Referring to Figure 4, perform the following procedure to install slide rail option
X968AA.
1. Remove the Inner-Slide Rail from the slide assembly (left and right) by de-
pressing the Slide Locking Latch and sliding the Inner-Slide Rail out from
the slide assembly.
2. Install the Inner-Slide Rail (left) on the Power Supply side by:
- removing the 2 bottom screws from the station power supply EMI cover,
and
- installing the Inner-Slide Rail (left) with the supplied screws.
3. Install the Inner-Slide Rail (right) on the PA side using the holes in the PA
casing.
4. Attach each Outer-Slide Rail to a Cabinet Bracket with supplied screws.
The left and right Cabinet Brackets are identical.
The Locking Tab of each Outer-Slide Rail must face towards the rear of the
cabinet.
5. The cabinet must have a set of vertical cabinet rails in the back as well as the
front. If there is no set in the back, these must be installed. The back rail is
installed the same as the front rail, with the supplied screws.
6. Install each assembled Cabinet Bracket (with attached Outer-Slide Rail) to
the appropriate side of the cabinet.
The U-shaped cutout of the Cabinet Bracket must face up.
7. Slide the station (with an Inner-Slide Rails mounted on each side) into the
Outer-Slide Rails in the cabinet; an audible snap is heard. Continue sliding
the station in until the station is fully seated.
8. Secure the station to the cabinet front rails with the supplied screws.
Installation
17