Motorola MTR2000 T5544 Instruction / Field Service Manual page 290

Cables
Note
Connector
45 cm
(18 in)
68P81096E41-D
09/30/05
The set of cables used to connect an Antenna Relay to the MTR2000 station
depends on what ancillary equipment is connected to the station.
A station can be configured with the following ancillary equipment:
- an Antenna Relay only.
Figure 2 shows the kits required when only an Antenna Relay is in-
stalled on a station.
- an Antenna Relay and an External Preselector.
Figure 3 shows the kits required when an Antenna Relay and an Ex-
ternal Preselector are installed on a station.
- an Antenna Relay and an External Double Circulator.
Figure 4 shows the kits required when an Antenna Relay and Exter-
nal Double Circulator are installed on a station.
- an Antenna Relay, an External Preselector, and an External Double
Circulator.
Figure 5 shows the kits required when an Antenna Relay, External
Preselector, and External Double Circulator are installed on a station.
Some of the ancillary equipment listed above is not available on all sta-
tions. For example, an External Preselector is not available for 800 or
900MHz stations.
To Tx RF
TKN9136
CLN6680
(cable and Antenna Relay)
Figure 2. Antenna Relay Only – Cable Kits
To Receiver
Module
Antenna Relay
61 cm
(24 in)
To
Backplane
Antenna Relay Module
From Receive
Antenna
TKN9132
Not
Connected
3