Optimization; Optimizing Tasks; Copying Station Codeplug Data To A Pc-Compatible Computer - Motorola MTR2000 T5544 Instruction / Field Service Manual

6

OPTIMIZATION

After the station and ancillary equipment have been mechanically installed, properly cabled, and power applied, the equip-
ment must then be optimized; that is, before placing the station in operation. Optimizing is performed through the Radio Ser-
vice Software (RSS), kit number RVN4148.
After the station is operational, the station's codeplug data must be copied to a PC- compatible computer.
CAUTION

Optimizing Tasks

Copying Station Codeplug Date To a PC-compatible Computer
CAUTION
68P81096E37-N
06/28/05
In order to program an MTR2000 station for Trunking operation, kit num-
!
ber RVN4148C (or later) of the RSS must be used. The current version is
available through the U.S. and Canada Americas Aftermarket Division
(AAD).
Optimization involves the following tasks:
1.
Reading the station codeplug from the station (this ensures a match between
the station serial number (resident in the codeplug) and the serial number
(part of the customized station codeplug data) that is written back to the sta-
tion (see task 5).
2.
Customizing the station codeplug and saving the data to the station
3.
Aligning the station for:
-
-
-
-
4.
Performing post-optimization procedures.
5.
Writing the customized codeplug to the station codeplug.
For details on these tasks, refer to the Optimizing a New Installation topic of the
Radio Service Software (RSS) Online Help.
A copy of each station's codeplug data must be made on an IBM-PC compat-
!
ible computer. This is done through the Radio Service Software (RSS). See
the RSS Startup Manual, 68P81096E15.
Rx Wireline
Tx Wireline
Receiver RSSI calibration (option)
Receiver Squelch Adjust
Installation
47