5
POST INSTALLATION CHECKLIST
After the station equipment has been mechanically installed and all electrical connections have been made, power may now
be applied and the station checked for proper operation.
Applying Power
Changing Fuse
CAUTION
68P81096E37-N
06/28/05
Before applying power to the station, make sure all boards are securely seated in
the appropriate connectors on the backplane and that all rf cables are securely con-
nected.
Turn ON the circuit breaker controlling the ac outlet that is supplying power to the
station Power Supply Module, or switch on the DC-supply to a station with a DC-
only Power Supply Module.
To replace the station fuse:
1.
Turn off station power at source (e.g., ac breaker).
2.
Remove fuse cover plate located on the backplane shield by unscrewing one
M4 screw.
3.
Pull defective fuse carefully with small needle nose pliers.
4.
Replace new fuse (part # 6583049X16) carefully with small needle nose pli-
ers.
For continued protection of the station against risk of fire, replace the
!
fuse only with the same type and rating of fuse.
5.
Restore power to the station.
Installation
43