Troubleshooting
1.
Disconnect cable (N-type
connector) from transmitter
antenna at station.
2.
Connect an N-to-N type cable
between the station and the
inline wattmeter.
4.
Connect the transmitter antenna to the
R2001 antenna input. Be sure to pull the RF
PORT SELECT knob out and select antenna
rf input.
5.
Remove front panel from
station, and connect
microphone to RJ-45 connector
(P5602) on front of Station
Control Module.
Figure 6.
14
Station
Transmit
Station - rear
Output
3.
Connect the inline wattmeter
to a dummy load.
Motorola R2001
Communications
Station - front
Test Equipment Setup for Verifying Transmitter Circuitry
Inline
Wattmeter
Antenna
Analyzer
Microphone
Connector on SCM
To Receive
Antenna
Station
Receive Input
Dummy
Load
RF port select knob
(pull out)
Service
MIcrophone
68P81096E17-E
09/30/05