Motorola MTR2000 T5544 Instruction / Field Service Manual page 74

Installation
Note
16
with an antistatic bag; do not remove the bag at this time.) Use a vacuum
while drilling the holes to minimize the spread of concrete dust. Carefully
clean up any accumulated dust and debris from the anchor installation before
uncovering the equipment.
Mounting Floor-mount Cabinets
Each cabinet bottom is pre-drilled with four (4) mounting holes to allow attach-
ment to the site floor. If installing on a concrete floor, use the cabinet as a tem-
plate, mark the hole locations, and follow the procedures above for anchoring
equipment racks. If installing on a wooden floor, use lag bolts and washers (cus-
tomer supplied) to secure the cabinet to the floor.
Transferring Equipment from Shipping Container to Rack or
Cabinet
As mentioned under Equipment Unpacking and Inspection, a station can be
shipped in a box. Upon delivery, the equipment must be removed from the con-
tainer and transferred to a Motorola-supplied rack or cabinet, or to a customer-sup-
plied rack or cabinet.
Customer-supplied cabinets and racks must have mounting rails and hole spacing
compatible with EIA Universal 48.3cm (19in) specifications. Cabinets must pro-
vide adequate ventilation (as detailed under Equipment Ventilation) and must
meet the following criteria:
- 41.3cm (16.25in) deep
- 48.3cm (19in) wide
- 13.4cm (5.25in) high
- Two mounting rails 5cm (2in) from front of cabinet with front mounting holes
5.7 cm (2.25in) apart (center to center).
Contact Motorola Engineering for specific questions regarding mounting equip-
ment in customer-supplied cabinets.
68P81096E37-N
06/28/05