Motorola MTR2000 T5544 Instruction / Field Service Manual page 104

Installation
FailSoft
FS
PA Keyed
FS
CAUTION
46
This FailSoft LED indicates the following:
LED
LED Color
Yellow
This LED is lit when no activity is detected on the transmit data signal from the
trunking central controller; the station is in Failsoft mode. This condition usually
indicates a failed link to the trunking central controller.
This PA Keyed LED indicates the following:
LED
LED Color
Green
Green
Listening For Audible Alarms
With a Service Speaker connected to the station (see Station Operation, Service
Connections), any active audible alarms can be heard.
Alarm
AC Fail
PA Fail
The audible alarms are repeated every 10 seconds. If more than one alarm is ac-
tive, they are offset by 2 seconds.
Exercising Radio Operation
Operation of the station radio can be verified by exercising the radio's two-way
operation. This may be carried out when an external speaker and microphone are
connected to the Station Control Module (SCM).
The kit # for the speaker is HSN1000. The external speaker requires an adaptor
cable, part # 0185180U01.
!
Using a speaker other than the recommended HSN1000 may result in the sta-
tion blowing a fuse.
The kit number for the microphone is GMN6147B.
LED State
Flashing station is in the Trunking system Failsoft
mode.
LED State
On PA is keyed.
Flashing PA is keyed, but operating with power
cutback.
Sound
a single short beep a station configured with DC-revert
has detected an AC power failure.
two short beeps the station has been keyed, and the
Power Amplifier has failed.
Indicates that the ...
Indicates that the ...
Indicates that ...
68P81096E37-N
06/28/05