Mipi-Dsi; Camera Interface; Usb Ports - Arrow SD 600eval Hardware User Manual

Table of Contents

6.6.2 MIPI-DSI

The 96Boards CE specification calls for MIPI-DSI implementation via the High Speed Expansion Connector.

The SD 600eval implemented a four-lane MIPI_DSI interface meeting this requirement. More information about this

implementation can be available in chapter 7.2 High speed expansion connector.

The 96Boards CE specification calls for two camera interfaces via High Speed Expansion Connector.

The SD 600eval implements two camera interfaces, one with a four-lane MIPI_CSI (CSI0 port) and other with two-lane MIPI_CSI

(CSI1 port) of APQ8064. More information about this implementation can be available in chapter 7.2 High speed expansion

connector.

The 96Boards CE specification requires two USB 2.0 Host ports, one Micro USB 2.0 slave port to be present on board and one

USB Host port to be provided on high speed expansion connector.

The APQ8064 supports two USB 2.0 host interface, one USB OTG interface and one HSIC interface. One USB host Interface and

HSIC interface of APQ8064 is connected to high speed expansion connector. The 2nd USB Host interface is connected to on-

board USB Hub, which supports 3 downstream ports. Two downstream USB ports of USB Hub are available at Type A connector

J12 (Host1) and J11 (Host2). USB OTG port is provided at USB Micro AB connector J14 of SD 600eval board. The USB host

controller supports full speed (12Mbps) mode, high speed (480Mbps) mode and Low Speed (1.2Mbps) mode.

Arrow.com.

Downloaded from

13/30

Table of Contents