Bomag BW 213 D-4 Operating Instructions, Maintenance Instructions page 98

Single drum roller
Hide thumbs Also See for BW 213 D-4:
Table of Contents

Advertisement

T r o u b l e s h o o t i n g
Faults
Possible cause
Excessive ex-
Engine oil level too high
haust smoke
Dry air filter dirty
Exhaust gas turbo-charger defective
Poor compression due to burned or bro-
ken compression rings or incorrect valve
clearance
Incorrect valve clearance
Engine over-
Cooling fins on radiator extremely soiled
heats, shut
(the warning light "engine oil temperature"
down immedi-
lights)
ately!
Injection valve defective
Engine oil level too low
Filling capacity of the injection pump not
correctly adjusted
Cooling air flow restricted
V-belt loos or broken
Poor engine
Engine oil level too high
power
Dry air filter dirty
Exhaust gas turbo-charger defective
Charge air hose leaking
Incorrect valve clearance
Injection valve defective
Engine oil pres-
Engine oil level too low (control light "en-
sure too low
gine oil pressure" lights, the warning
buzzer sounds)
Leakages in the lubrication system
The charge con-
Generator speed too low
trol light lights
during opera-
The generator does not charge the bat-
tion, the warning
tery, because generator or regulator is de-
buzzer sounds
fective
9 8
Remedy
Drain the oil to the upper dipstick mark
clean, replace if necessary
Have examined by a specialist
Have compression rings and pistons ex-
amined by a specialist, adjust the valve
clearance
Adjust the valve clearance
Clean the cooling fins
Have examined by a specialist
Top up engine oil to the upper dipstick
mark
Have adjusted by a specialist
Clean the cooling air duct
Tension or replace the V-belt
Drain the engine oil down to the upper dip-
stick mark
clean, change if necessary
Have examined by a specialist
Check fastening and connections
Adjust the valve clearance
Have examined by a specialist
Top up oil
Shut the engine down immediately, check
fittings on oil lines, lubrication oil filter and
oil cooler for leaks, if necessary tighten
the fittings.
Check the V-belt tension, replace the V-
belt if necessary
Have examined by a specialis
B O M A G
BW 213 D-4

Advertisement

Table of Contents
loading

Table of Contents