Bomag BW 213 D-4 Operating Instructions, Maintenance Instructions page 17

Metal objects (e.g. tools, rings, wrist watches)
must not contact the battery poles - danger of
short circuit and burns!
When recharging maintenance free batteries re-
move the plugs to avoid the accumulation of explo-
sive gases.
When using an external battery to start the ma-
chine follow the respective instructions.
Dispose of old batteries environmentally.
Switch the charging current off before removing
the charge clamps.
Ensure good ventilation, especially when charging
the battery in a closed room.
Working on the fuel system
Do not inhale fuel fumes.
No open fire, do not smoke, do not spill any fuel.
Catch running out fuel, do not let it seep into the
ground and dispose of environmentally.
Working on wheels and tires
Explosion like bursting of tires and parts of rims
and tires can cause severe or even deadly injuries.
Assemble tires only with the appropriate knowl-
edge and tools. If necessary have the tires assem-
bled in a special workshop.
Ensure correct tire pressure and do not exceed the
highest specified pressure.
Check wheels and tires every day for specified
pressure, cuts, bulges, damaged wheel rims,
missing wheel studs and nuts. Do not drive with
damaged tires or wheels.
Anti-stick emulsions for tires must only be mixed
using water and concentrated anti-stick agent ac-
cording to the specifications of the manufacturer of
the anti-stick agent. Observe the regulations for
the protection of the environment.
Cleaning
Do not clean the machine while the engine is run-
ning.
Do not use gasoline or other combustible sub-
stances for cleaning purposes.
When using steam cleaning equipment do not
subject electrical components and insulating ma-
BW 213 D-4
terials to the direct water jet, but cover them be-
forehand.
Do not guide the water jet into the exhaust or
l
into the air filter.
After maintenance work
Reinstall all protective devices after completing
the maintenance work.
Repair
Attach a warning tag to the steering wheel if the
machine is defective.
Repairs must only be performed by qualified per-
sons who have been instructed for this purpose.
Use our repair instructions.
Exhaust gases are highly dangerous! Always en-
sure an adequate supply of fresh air when starting
in closed rooms!
Test
Depending on the type of application and the op-
erating conditions vibratory equipment has to be
examined by a specialist whenever required, but
at least once every year.
B O M A G
S a f e t y r e g u l a t i o n s
1 7