Bomag BW 213 D-4 Operating Instructions, Maintenance Instructions page 64

E v e r y 5 0 0 o p e r a t i n g h o u r s
Every 500 operating h ours
5.17 Changing engine oil and oil
filter cartridges
Caution
!
The oil change at 500 operating hours refers to
the use of oils of oil quality class API CG-4/CH-
4 or ACAE E3-96/E5-02 respectively.
Refer also to the chapter 5.2, fuels and lubri-
cants.
Drain the engine oil only when the engine is
warm.
Danger
!
Danger of scalding!
When draining off hot oil.
By hot oil when unscrewing the engine oil fil-
ter.
Environment
Catch running out oil and dispose of environ-
mentally together with the engine oil filter car-
tridge.
Fig. 81
Unscrew the drain plug (Fig. 81) and catch
l
running out oil.
Turn the drain plug tightly back in.
l
6 4
Fig. 82
Thoroughly clean the outside of both filter car-
l
tridges (Fig. 82).
Unscrew both filter cartridges using an appro-
l
priate filter wrench.
i
Note
The filter cartridges are fitted with a valve that pre-
vents engine oil from running out during removal
and installation.
Clean the sealing face on the filter carrier from
l
any dirt.
Slightly oil the rubber seal on the new filter car-
l
tridges.
Fig. 83
Turn the new filter cartridges (Fig. 83) on by
l
hand, until the seal contacts.
Tighten the filter cartridges for another half
l
turn.
B O M A G
BW 213 D-4