Bomag BW 213 D-4 Operating Instructions, Maintenance Instructions page 75

5.25 Checking / replacing the
ribbed V-belt
Danger
!
Danger of injury!
Work on the V-belt must only be performed
with the engine shut down.
Checking the wear limit of the ribbed V-
belt
Fig. 109
Check the distance between the tongue of the
l
moveable tensioner arm and the fixed tension-
er housing (Fig. 109).
If measurement "a" is smaller than 3 mm, re-
l
place the ribbed V-belt.
BW 213 D-4
Changing the ribbed V-belt
Fig. 110
Unscrew the fastening screws (Fig. 110) and
l
slide the fan forward.
Fig. 111
Release the idler pulley (Fig. 111) in direction
l
of arrow until the ribbed V-belt is free.
Pull the ribbed V-belt first to the smallest pul-
l
ley.
Install the new ribbed V-belt.
l
Release the idler pulley against the direction
l
of arrow until the V-belt is tensioned.
Measure the V-belt tension, tighten if neces-
l
sary.
i Note
Retighten the new fan V-belt after a running time
of 20 minutes.
B O M A G
E v e r y 1 0 0 0 o p e r a t i n g h o u r s
7 5