Bomag BW 213 D-4 Operating Instructions, Maintenance Instructions page 77

Fig. 114
Fill in oil through the oil level inspection bores
l
(Fig. 114), until it has reached the bottom edge
of the bore.
i Note
The second level inspection plug as at the back.
After filling in oil wait until the oil has evenly distrib-
uted inside the axle.
For quality and quantity of oil refer to the table
of fuels and lubricants.
Retighten the filler and level inspection plug.
l
BW 213 D-4
5.28 Changing the oil in the
wheel hubs
Caution
!
Drain oil only at operating temperature.
Change the oil on both sides of the axle.
Environment
Catch old oil and dispose of environmentally.
Fig. 115
Move the drive wheel, until the plug (Fig. 115)
l
is in bottom position.
Clean and unscrew the plug.
l
Drain and catch all oil.
l
Fig. 116
Move the drive wheel, until the plug (Fig. 116)
l
is in horizontal position on the housing.
Fill in oil, until it reaches the bottom edge of the
l
bore.
B O M A G
E v e r y 1 0 0 0 o p e r a t i n g h o u r s
7 7