Bomag BW 213 D-4 Operating Instructions, Maintenance Instructions page 44

O p e r a t i o n
After towing
Caution
!
Before detaching the tow bar block the ma-
chine with chocks to prevent unintended roll-
ing.
Turn the high pressure relief valve cartridges
l
tightly back in.
Turn all brake releasing screws of the axle
l
evenly back out, until they are light moving
again.
Fig. 62
Turn the brake releasing screws (Fig. 62) back
l
in again, until they abut against the brake pis-
ton.
Fig. 63
Unscrew the brake releasing screws (Fig. 63)
l
for two turns and tighten the counter nuts.
Repeat this adjustment procedure on the op-
l
posite wheel side.
4 4
i Note
If necessary replace the seal ring under the coun-
ter nut if it is leaking.
For this purpose completely unscrew the brake re-
leasing screw, replace the seal ring and lubricate
the screw with silicone grease.
Reinstall the screw with a new seal ring and adjust
the protrusion as described above.
B O M A G
BW 213 D-4