Power Connection; Connector - Kontron MOPS/386A User Manual

Kontron

POWER CONNECTION

16.
In some applications, the MOPS/386A is intended for use as a stand-alone module without
a backplane. You need to have a power connector available on the board for direct power
supply. The MOPS/386A is a +5V-only board. Peripherals can obtain additional voltage from
the power connector next to the PC/104 bus. The additional voltages (+12V, -5V and -12V)
are not generated onboard the MOPS/386A.

Connector

16.1
The power connector is available as X1C (8 pins).
The following table shows the pinout.
Header Pin
1
2
8
To find the location of the power connector on the MOPS/386A board, please see the
Appendix E: Connector Layout chapter.
MOPS/386A User's Guide
Signal Name
1 GND
2 VCC
3 BATT
4 +12V
5 -5V
6 -12V
7 GND
8 VCC
31
Function
Ground
+5V
Battery
+12V
-5V
-12V
Ground
+5V
Power Connection