Risk Caused By Heat; Risk Caused By Unexpected Pump Start-Up; Risk Of Drowning In The System Chamber - Kessel Aqualift F XL Instructions For Installation, Operation And Maintenance

Pumping station, dry set-up
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 41

2.4.7 Risk caused by heat

Risk of burning by touching hot surfaces. When in operation for longer periods, wastewater pumps develop a
high temperature on the housing surface. Wear protective equipment (gloves) or allow the pumps to cool down
accordingly.

2.4.8 Risk caused by unexpected pump start-up

Any pump can start up at any time if the pumping station is not disconnected from the power supply. Always
have specialist staff remove the pumps and only after the system has been cleared and secured against being
switched on again unintentionally.

2.4.9 Risk of drowning in the system chamber

In the event of a flood, a system chamber can fill with water within a very short time. If there is a risk of water
entering, the inspection chamber must not be entered until there is no danger involved.
The pump must not be opened;
the pump is sealed to IP68. No humidity will enter provided the pump is installed correctly. Provide a fault
current circuit breaker
Safety
52 / 240
2016/05

Advertisement

Table of Contents
loading

Table of Contents