Husqvarna Automower 310 Technical Manual page 50

4. AUTOCHECK EXPERIENCE, SERVICE PROGRAM
is used. Autocheck EXP itself checks which software
is suitable for the connected mower. At times, there
may be a need to answer questions to supplement the
inspection. Read the questions carefully so that they are
answered correctly.
IMPORTANT INFORMATION
Always let Autocheck complete a started
programming process! An interrupted programming
can block the mower's main circuit board or HMI
circuit board.
Programming a blocked HMI circuit board
If the HMI circuit board is locked so that it cannot
communicate or be programmed in the usual way it can
be placed in a so-called boot mode. This should only
be used if the usual programming procedure does not
succeed.
1. Put the main switch in position 0.
2. Connect the USB cable and start Autocheck EXP.
3. Keep the 0 key pressed in.
4. Put the main switch in position 1 (at the same
time as keeping the 0 key pressed in).
5. The text Loading Language is shown in the
display. Now start Programming in Autocheck
EXP.
Programming a blocked main circuit board
If the main circuit board is locked so that it cannot
communicate or be programmed in the usual way it can
be placed in a so-called boot mode. This should only
be used if the usual programming procedure does not
succeed.
1. Put the main switch in position 0.
2. Connect the USB cable and start Autocheck EXP.
3. Lift and hold the mower by the front edge
so that the lift sensor is activated.
4. Put the main switch in position 1 (while at the
same time lifting the mower by the front edge).
5. Start Programming within 10 seconds.
Programming new main circuit board
If the main circuit board is replaced, the new main circuit
board must be programmed. The main circuit board
includes for instance information about the robotic
lawnmower's serial number. A new main circuit board
may for safety reasons be only assigned one serial
number which is never changed. It is therefore very
important that the correct serial number is given.
English - 50
TH_1158203_310_315_GARDENA_US.indd 50 2016-05-11 10:16:14