Husqvarna Automower 310 Technical Manual page 60

4. Remove the guarantee seal at the point
of separation between the chassis halves on
the right-hand side.Carefully lift the back edge
of the upper section of the chassis.
5. Disconnect the HMI cable from the main
circuit board and remove the upper section
of the chassis.
5.2.3 Disassembling the display cover
The display cover is mounted on the chassis with four
screws. To enable the parts to be fully separated, all
cabling between the HMI circuit board and the upper
section of the chassis must be disassembled from the
HMI circuit board.
1. Disassemble the body. See 5.2.1
Disassembling the body on page 59.
2. Disassemble the chassis. See 5.2.2
Disassembling the chassis on page 59.
3. For GARDENA models with Smartsystem, the
Smartsystem board must be removed. See
5.9 Replacing the GARDENA Smartsystem
board on page 66.
4. Unscrew the four screws (Torx 20) from the
underside of the upper chassis section.
5. Carefully lift the display cover so as not to
damage the cables connecting the chassis
and display cover.
6. Disassemble the HMI cable from the HMI
circuit board.
English - 60
TH_1158203_310_315_GARDENA_US.indd 60
5. REPAIR INSTRUCTIONS
2016-05-11 10:16:24