Battery Test - Husqvarna Automower 310 Technical Manual

4. If the LED is flashing yellow in test b) then
the break is somewhere in the boundary wire
between AR and the position where the guide
wire is connected to the boundary wire (thick
black line in illustration B).
5. Put all connections back in their original
positions. Then disconnect AR. Connect a new
loop wire to AR. Connect the other end of this
new loop wire somewhere at the centre of the
installation. If the LED turns green then the
break is somewhere in the section between
the disconnected end and the position where
the new wire has been connected (thick black
line in illustration C). If that is the case, move
the connection for the new wire closer to the
disconnected end (approximately in the middle
of the suspected section) and check again
whether the LED has turned green. Continue
until only a very short section of the wire
remains which is the difference between a
flashing blue light and a solid green light.
6. When the break is found, the damaged
section must be replaced with a new wire. The
damaged section can be cut out if it is possible
to shorten the boundary wire. Use only original
couplers from the Husqvarna.

6.6 Battery test

If the mower's battery starts to perform poorly,
the robotic lawnmower will mow for shorter time
periods. The mower can also stop and show the Low
battery voltage message. To establish whether the
battery is functioning unsatisfactorily a battery test
is recommended.
A battery test is also recommended in connection with
the mower's winter service. An inferior battery can then
be replaced before the next season starts.
6.6.1 Performing a battery test
1. Checking the battery's capacity requires that
the battery is completely flat. Use manual
operating mode and fully charge the battery.
When charging commences the battery
temperature should not be more than 40º C /
104º F.
TH_1158203_310_315_GARDENA_US.indd 94
6. TROUBLESHOOTING
Guide1
B
AL
AR
C
AL
AR
2016-05-11 10:16:47